For pricing and availability, please contact one of over 50 Miller Paint stores throughout Oregon, Washington and Idaho. Also available at many authorized dealers.
SHEENS
EXTERIOR WHITE VELVET
A flat finish will minimize visibility of surface imperfections due to light refraction. It is best used for rough surfaces, or surfaces that are regularly repainted or touched up.EXTERIOR WHITE SATIN
RED VELVET
A flat finish will minimize visibility of surface imperfections due to light refraction. It is best used for rough surfaces, or surfaces that are regularly repainted or touched up.RED SATIN
YELLOW VELVET
A flat finish will minimize visibility of surface imperfections due to light refraction. It is best used for rough surfaces, or surfaces that are regularly repainted or touched up.YELLOW SATIN
Coverage
Approximately 300 to 400 square feet per gallon. Two coats recommended. Coverage depends on porosity and profile of surface and can be less when making a significant change in color.
Drying Time
1 hour to touch, and 4 hours for recoat at 70°F and 50% relative humidity.
Disposal
Never pour leftover material down any sink or drain. Use up material on the job, or seal can and store safely for future use. Do not incinerate closed containers. For specific disposal guidelines contact your local waste management agency or visit millerpaint.com/paint-recycling. Please re-use or recycle.
SURFACE PREP
REPAIR cracks and fill voids with a paintable patching/caulking material. Degloss all shiny, smooth, hard, or glossy surfaces by lightly sanding. Remove all loose and scaling paint.
CLEAN all paintable surfaces to be free of dirt, dust, oil, grease, wax, and other contaminants. Rinse and allow surface to dry completely.
PRIME unsealed surfaces such as ferrous metal, plaster/wallboard, cedar, redwood, and other wood surfaces that may contain tannins or water stains with an appropriate Miller Paint primer. Test for adhesion and compatibility when painting over existing finishes.
STIR thoroughly before use. Thinning not recommended. If necessary, use a small amount of clean tap water. Do not use solvent to thin.
APPLY using nylon or synthetic brush, pad, roller, or spray. Do not apply when surface temperatures are below 35°F or when temperatures are expected to drop below 35°F within 24 hours. Keep product from freezing.
CLEANUP by removing all paint spatters, and wash all brushes and equipment immediatley with warm soapy water. Follow with a clear rinse.
The contents of this can should be well stirred or boxed by pouring from one can to another to assure color uniformity. More than one can of the same color should be mixed together as you progress with your work. Check color before painting, not responsible for application of wrong shade. Custom colors are not returnable.
Your satisfaction with Miller Paint products is guaranteed. Learn more at millerpaint.com/promise.
